Installation: Trial user
Installation step by step:
  1. Before installing the components package, please close all Delphi and C++ Builder IDEs.

    Note, for each IDE, if it's a clean installation, please run it at least once before installing the components package, then closes it and continues installation.

  2. Run the installation file barcode2d_tri.exe, and then click on the "Next" button in the installation dialog box.
  3. Read the End-User License Agreement. You must accept the terms of this agreement before continuing with the installation. And then click on the "Next" button.
  4. Specify a target folder (it will be created if does not exist), the components package will be installed into it. And then click on the "Next" button.
  5. All supported Delphi and C++ Builder IDEs will be listed automatically according on the existing IDEs in your computer. Please select the IDEs you want to install to them. And then click on the "Next" button.

    Note, The Delphi 4, 5, 6, 7, 2005, 2006, 2007, 2009, 2010, XE, XE2, XE3, XE4, XE5, XE6, XE7, XE8, 10 Seattle, 10.1 Berlin, 10.2 Tokyo, 10.3 Rio, 10.4 Sydney, 11.3 Alexandria, 12.2 Patch 1, 2 Athens, and C++ Builder 4, 5, 6, 2006, 2007, 2009, 2010, XE, XE2, XE3, XE4, XE5, XE6, XE7, XE8, 10 Seattle, 10.1 Berlin, 10.2 Tokyo, 10.3 Rio, 10.4 Sydney, 11.3 Alexandria, 12.2 Patch 1, 2 Athens are supported now. The Delphi 2006, 2007, 2009, 2010, XE, XE2, XE3, XE4, XE5, XE6, XE7, XE8, 10 Seattle, 10.1 Berlin, 10.2 Tokyo, 10.3 Rio, 10.4 Sydney, 11.3 Alexandria, 12.2 Patch 1, 2 Athens and C++ Builder 2006, 2007, 2009, 2010, XE, XE2, XE3, XE4, XE5, XE6, XE7, XE8, 10 Seattle, 10.1 Berlin, 10.2 Tokyo, 10.3 Rio, 10.4 Sydney, 11.3 Alexandria, 12.2 Patch 1, 2 Athens are listed as RAD Studio (Delphi & C++ Builder) 2006, 2007, 2009, 2010, XE, XE2, XE3, XE4, XE5, XE6, XE7, XE8, 10 Seattle, 10.1 Berlin, 10.2 Tokyo, 10.3 Rio, 10.4 Sydney, 11.3 Alexandria, 12.2 Patch 1, 2 Athens.

  6. Specify a shortcuts folder in "Start Menu" for the components package. And then click on the "Next" button. Later, you can open the manual or remove the components package in the shortcuts folder.
  7. Click on the "Install" button to complete the components package installation.
  8. Click on the "Finish" button to close the installation dialog box.
  9. You can start your IDE to use the components package now.
Note:

Contents